Orca Slicer for QIDI printers

Orca Slicer works well with QIDI’s enclosed, high-speed printers, which run Klipper. Machines like the X-Max 3, Q1 Pro and Plus4 are built for speed and for higher-temperature materials, and Orca’s Klipper support and calibration suite suit them well. This page covers the models, connecting them, and using the enclosure.

Supported models

Orca has profiles for the X-Max 3, the X-Plus 3, the Q1 Pro, the Plus4 and the smaller X-Smart 3, among others. These are CoreXY machines running Klipper, most with an enclosure and an actively or passively heated chamber for materials like ABS, ASA and PC.

Connecting and setup

Pick your exact QIDI model when you add the printer, so the right build size and start code load, then connect over your local network. If your exact model is not listed, a generic Klipper profile matched to your bed size gets you printing. QIDI ships its own slicer based on the same family, so profiles and habits will feel familiar.

Using the enclosure

The enclosure is the reason to reach for these printers with warp-prone materials. Where the machine can hold a chamber temperature, set it on the chamber temperature control page for ABS, ASA and similar, and leave it off for PLA and PETG. Then set the bed type to match your plate, and run the flow rate and pressure advance tests for your filament. Back to all printers.

Frequently asked questions

Does Orca Slicer work with the QIDI X-Max 3?

Yes. Orca has a profile for the X-Max 3, an enclosed CoreXY machine running Klipper. Orca connects over your network, and its calibration suite helps you get clean, fast prints. Its enclosure suits ABS, ASA and other warp-prone materials.

Can I print ABS on a QIDI in Orca Slicer?

Yes, and the enclosure is what makes it reliable. Where your QIDI can hold a chamber temperature, set it for ABS or ASA and turn on the enclosure, while leaving the chamber off for PLA and PETG. Match the bed type to your plate and calibrate the filament for the best result.